PV Powered PVP4800 Información técnica descargar pdf (Pagina 19)

3.1 Mounting and Anchoring the Inverter and Integrated

AC/DC Disconnect

After you have determined a suitable location for the inverter/disconnect

unit, the next step is anchoring the bracket to the wall stud(s).

Models PVP1100, PVP2000, PVP2500, PVP2800, PVP3000

and PVP3500

1. Locate a wall stud in the desired location and align the mounting

bracket or paper mounting template with the vertical row of screw

holes over it for a single-stud mount. Mark the mounting holes

ensuring holes A through D are directly over the single stud.

2. VERIFY THE BRACKET IS LEVEL. Align points A through D with

the wall stud. Drill 1/8” (.32 cm) pilot holes for the screws.

• Use heavy-duty 1/4” x 2” (.635 cm x 5 cm) (coarse thread lag

screws to secure points A, B and D.

• Use an 1/8” (.32 cm) screw (and anchor if necessary) to secure

point C. Refer to the following gure.

Figure 3-1 Small Mounting Bracket

3. Carefully hang the inverter/disconnect unit on the upper part of the

bracket. The hooks located at the rear of the inverter should hang over

the bracket.

4. Verify the inverter/disconnect unit is level.

5. Remove the front lid of the inverter by unscrewing the two cover

screws located at the bottom perimeter of the inverter.

3. Installation

INSTALLATION

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 83 84

Sin comentarios

PV Powered PVP4800 Información técnica Pagina 19