PV Powered PVP260kW Información técnica descargar pdf (Pagina 77)

6. Operation

6.1 Start Up Procedure

WARNING

Before turning on the inverter, ensure that the front panels are closed properly.

AVERTISSEMENT

Assurez-vous de la bonne fermeture des panneaux antérieurs avant de mettre

l’onduleur en route.

To start the inverter, complete the following steps in order:

1. Prior to engaging the disconnect switches, check the polarity of the DC positive and

negative connectors to ensure they are wired correctly and conrm the PV panel

open circuit voltage is at or below 600 VDC.

2. Close all upper and lower cabinet doors.

3. Turn on the external AC connection to the inverter.

4. Turn on the external DC disconnect to provide DC power to the inverter.

5. Turn the ON/OFF switch to the OFF position.

The ON/OFF switch is located next to the display screen.

6. Turn the inverter’s AC disconnect to the power ON position. Refer to Figure 6-1.

The display on the upper front panel should now be active. The display is shown

in Figure 6-3.

7. Turn the inverter’s DC disconnect to the power ON position. Refer to Figure 6-1.

8. Turn the ON/OFF switch to the ON position.

After ve minutes, the inverter starts to produce power into the AC grid if all necessary

operating conditions are met.

OPERATION

1 2 ... 72 73 74 75 76 77 78 79 80 81 82 ... 128 129

Sin comentarios

PV Powered PVP260kW Información técnica Pagina 77