
SMA Solar Technology AG Electrical Connection
Installation Manual SB25_30-IA-IEN115050 31
4. Push the cable gland toward the thread and fasten to a torque of 2 Nm.
☑ The DC connectors are assembled and can now be connected to the inverter as described in
Section 5.4.4 "Connecting the PV Array (DC)" (page33).
☑ If the conductors are not visible in the
hollow cavity, the cable is not in the correct
position.
• Loosen the clamping bracket. For this
purpose, use a screwdriver with a blade
width of 3.5 mm.
• Remove the cable and start again from
step 1.
Result Measure
Comentarios a estos manuales