PV Powered PVP2000 Especificaciones descargar pdf (Pagina 14)

PV Powered LLC 13 32-29-28-20-306

If at any moment the operating environment moves outside the safe operating limits,

governed by UL 1741, IEEE 519, and NEC 690, the “STAND BY” (Red) LED indicator will

be illuminated.

The StarInverter is continuously monitoring:

1. The AC grid connection to ensure the AC voltage and frequency levels are within

safe operating limits (per UL and NEC specifications).

2. The DC PV panel input(s) to ensure safe operating conditions (per UL and NEC

specifications).

3. The StarInverter itself to ensure only safe operating conditions exist within the

operating environment.

If all 3 conditions are met the inverter will illuminate the “OK” (Green) LED.

If any one of the operating conditions is not met there is a fault and the StarInverter will

illuminate the “STAND BY” (Red) LED.

The “STAND BY” (Red) LED will illuminate when the PV panel voltage is not within safe

operating limits. This will occur at sunset, when the inverter will turn off for the night. It

may also occur when clouds reduce the amount of sunlight, or when the panels are

covered with snow. Anytime the DC output from the PV panels drops below the inverter’s

minimum DC operating voltage, the inverter will turn off. This ensures only safe and

clean (low distortion) power is being generated. When the panels are once again exposed

to enough sunlight, the StarInverter’s auto-start feature will begin, and after 5 minutes,

the “OK “ (Green) LED should illuminate.

If the “STAND BY” (Red) LED continues to illuminate when there is sufficient sunlight for

operation, verify all wiring connections are solid. See Section 4.0 Troubleshooting. If the

StarInverter Command Center is communicating with the inverter, the exact operating

conditions can be determined in real-time.

VACUUM FLOURESCENT DISPLAY

The vacuum fluorescent display will indicate the StarInverter status and real-time power

output into the AC Grid. This display will provide the following information:

• AC power produced in real-time

• PV input in real-time

• Total Output as kW-hr

• Greenhouse gases saved in lbs

If a fault has occurred, the display will also provide a fault code that corresponds to a set

of defined faults. Please refer to Section 4.0 Troubleshooting.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 22 23

Sin comentarios

PV Powered PVP2000 Especificaciones Pagina 14